Whirlpool Refrigerator Filter 4396508

Description

The Whirlpool refrigerator filter 4396508, with multi-layer adsorption media, is designed to filter the water of side-by-side refrigerators of this brand. The combination of filter layers helps reduce chlorine and suspended particles in the water and is suitable for the dispenser and ice maker system.

Features of the Whirlpool 4396508 Side-by-Side Water Filter

The Whirlpool refrigerator filter 4396508 (main code 4396510 and alternative code EDR5RXD1B) has a standard construction and removes impurities entering the appliance. In addition to improving the taste and odor of the water, using this filter helps prevent scale build-up and damage to the internal parts and the solenoid valve of the appliance.

• Filtration capacity: 200 gallons (757 liters) of water
• Dimensions: 19.5 cm long with a 5.5 cm cross-section diameter (short twist-type model)
• Approximate weight: about 220 g
• Material: compressed activated carbon core of entirely plant origin, with a safe, standard (food-grade) body
• Filter location: can be installed in the internal compartment or base of Whirlpool and Maytag side-by-side refrigerators with part numbers 4396508 and 4396510; twist-lock connection mechanism (short twist type)
• Certifications: holds recognized international water health and quality certifications, including NSF/ANSI standards 42 and 53

This filter has a direct effect on the clarity of the ice and the purity of the output water.

How to Install the Whirlpool Rocket-Type Refrigerator Filter (Model 4396508)

The Whirlpool 4396508 internal filter (main code 4396510) is a rocket type with a twist mechanism, usually located in the ventilation grille at the bottom of the appliance, and it is fully compatible with the Maytag and Amana brands as well. To replace it quickly and safely, follow these steps:

1. Before anything else, close the refrigerator’s water supply valve. Press the dispenser paddle for a few seconds to let the pressure trapped in the plumbing release completely.
2. Turn the used filter 90 degrees to the left (counter-clockwise) in its housing to release it from the latch, then pull it straight out.
3. Remove the protective cap from the new filter. Carefully align it with the grooves, push it in, and turn it a quarter turn to the right (clockwise) until it is fully locked and sealed.
4. Open the water valve again. To purge the lines and flush out the initial activated carbon fines, be sure to dispense and discard about 4 to 5 liters of water.

Resetting the sensor: when you are done, hold the Filter Reset key on the refrigerator display for 3 seconds so the replacement warning light turns off and the timer resets.

Frequently asked questions

• How often should the Whirlpool filter be replaced?
  Normally every 6 months or after filtering 1,500 liters of water.
• How can I be sure the filter is genuine?
  Genuine filters come with a hologram, barcode, and standard packaging.
• Is this filter compatible with Maytag and Amana refrigerators?
  Yes, the 4396508 filter is fully compatible with Maytag, Amana, and Kenmore models as well.
• Do I need a technician to install the filter?
  No, installation is very simple and you can do it yourself in under 2 minutes.